DESCRIPTION
EPOXY GROUT is hygienic, stain-resistant, 3 component epoxy resin- based grout with a high degree of resistance to chemical attack, abrasion and impact. The cured grout does not transfer taints to food products, prevents the entry of bacteria or dirt and is easily maintained in a sterile condition. EPOXY GROUT is designed for grouting glazed tiles, mosaic, vitrified and fully vitrified tiles, ceramic tiles, industrial tiles, granites, marbles & other natural stones, etc.
STANDARDS
- Exceeds EN 13888 requirements
AREAS OF APPLICATION
- Walls and Floors
- Interiors and Exteriors
- Dry areas
- Showers
- Swimming Pools
- Heavily Trafficked Floors
- Hygienic Sterile Areas
- Kitchens and Cafeterias
Note
- Do not use showers for at least 2 weeks following completion ofgrouting.
- Do not fill pool at least 3 weeks following completion of grouting.
FEATURES
- Hygienic and chemical resistant
- Stain and bacterial resistant
- Can be cleaned off in 15 minutes and up to 60 minutesafter application
- Provides high strength and durable joints
- Suitable for submerged conditions
- Easy to be cleaned from tiled surface
- Suitable for joint width of 1 – 12 mm
- Available in a wide range of colours
PHYSICAL PROPERTIES
EPOXY GROUT @ 27± 1°C
Mixed Density 1.70
Joint Width 1 – 12 mm
Pot Life 45 minutes
Foot traffic 24 hours
Full cure 7 days
Temperature Prolonged -30°C to 50°C
Resistance Intermittent upto 70°C
CHEMICAL RESISTANCE CHART
Shoolin Chemicals “Chemical Resistance” chart.
Bond strength >1.5 N/mm²@ 7days
Tensile Adhesion 4.5 kN 14 Days air
Compressive strength >55 N/mm²@ 7days
Flexural strength > 20 N/mm²@ 7days
Water Absorption Nil
Shore D Hardness > 70
VOC Content 113.78 g/l
COVERAGE ESTIMATES
Pack size
5 kg &1 kg sets Coverage
Consumption depend on joint width, size of tiles
Theoretical coverage calculation: (Tilelength+Tilebreadth)x TilethicknessxJointwidthx MixedDensity* (Tilelength+Jointwidth)x(Tilebreadth+Jointwidth)
NOTE:
* Mixed Density = 1.70
All the dimensions are in mm
APPLICATION INSTRUCTIONS
Surface Considerations
-
- Before commencing grouting, the adhesive bed must be set.
- The joints must be clean of all adhesive residue, dust or debris.
- Lightly sponge the tile surface to remove dust & dirt. Movement Joints: These should be provided in accordance with BS 5385:part 1 – 5 and may be filled with the appropriate flexible sealant. Intermediate floor joints should be reinforced with brass or stainless steel. Use stainless steel where hygiene is essential.
Mixing
The entire contents of PART A and PART B should be poured into a clean mixing vessel and mix to a uniform consistency. Slowly add PART C until the Required slump free smooth paste is obtained. Immediately pour the mixed grout onto the working area.
Application
-
- Using a hard rubber grout float, compact the EPOXY GROUT into the joints ensuring that they are completely filled. Work in small areas and remove as much
excess from the tile/stone surface as possible. Strike off
excess materials diagonally to the grout lines.
